dichtol WFT is a very thin, high-performance polymer for infiltration, impregnation and sealing of porous structures, layers and components. dichtol WFT independently penetrates porous structures and cracks and seals them permanently and reliably. The product has a very high capillary activity and cures without heat input under ambient conditions. The application is done atmospheric, i.e. without vacuum or pressure. The cured polymer fills open pores or cracks and has good resistance to oils, lubricants and coolants.
Efficient material consumption due to punctual application even with vagrant porosities
Various applications by dipping, injecting, spraying or brushing
Good chemical resistance
Temperature resistant up to + 300°C
Drinking water and food authorisation
Impregnation of metals, impregnation of castings
Sealing of thermally sprayed coatings (sealers for APS, HVOF, LDS, flame spraying)
Infiltration of 3D printed components, additive manufacturing, generative manufacturing
Storage / Shelf life
Store in original, unopened container in a cool, dry place (+5°C to +30°C). Shelf life 5 years.
Processing / Preparation
Dirt residues, foreign bodies, grease and other substances must be completely removed from the pores to be sealed. Crack testing agents can have a negative effect on the penetration behaviour of the sealer. For cleaning dirty surfaces we recommend DIAMANT Cleaner #1417.
The product is a 1-component system. Please observe the application temperatures specified in the technical data. Application on too warm surfaces as well as application at too low temperatures can negatively influence the penetration behaviour of the sealer.
Brush & Spray
apply sealant crosswise in 4 working steps at intervals of about 1 minute. Keep damp on the surface for at least 5 minutes to ensure sufficient time for deep penetration.
Inject & Fill
dichtol into the space to be sealed (e.g. blind hole, threaded hole, cooling channel, etc.) and allow to react for at least 5 minutes. Then, if necessary, pour off excess material.
Dip the component to be treated in dichtol and after a reaction time of at least 2 minutes, apply dichtol again. Remove again after 5 minutes. Please make sure to drain the component properly. It is recommended to move the component during dripping to prevent deposits of dichtol from forming in undercuts or cavities.
dichtol cures completely under room conditions. Curing can be accelerated by temperature.
Our payment and shipping partners
Do you have any questions? We will be happy to help you.
Would you like expert advice on which of our products is best suited for you? Then simply contact one of our service technicians! We will be happy to help you, whether you contact us by phone, fax or mail.