RepaCoat CP-V is a cold-curing expoy formulation developed for a special way of processing. Through the use of special resins and hardeners and inert fillers, RepaCoat CP-V achieves outstanding resistance to aggressive chemicals.
RepaCoat CP-V is a liqiud 2-component polymer material, with highly wear-resistent, ceramic fillers. The product is characterized by a good flow and high drainage strength. The preferred application is in areas where extremly high wear protection against impacting solid particles is needed (particles in liquid media, gases and bulk solids).
Easy and time-saving application by spraying with the RepaCoat Venturi system
Protects the base material from abusive loads and aggressive media
Resistant to most inorganic acids and at the same time against aggressive organic acids
High resistance to solvents
High wear protection with extreme abrasive demand
Filled with high quality ceramic filters
High drainage strength
Tanks, tubes, pipes and pumps
Chemical industry, oil industry
Exhaust systems, extruders, fans,
Pipes (especially downpipes), slides,
Containers for bulk materials
Exhaust systems (temperature limit),
Conveyor systems including screw conveyors,
all types of mixers (container and agitator) etc.
Retention / Durability
store dry, cool and frost-free in the original unopened container (+5°C to +20°C) °C). Shelf life 2 years. Protect from direct sunlight. High temperatures reduce shelf life.
Preparation / Surface condition
Roughening of the surface by sandblasting (preferably) or grinding, up to a roughness depth of 100μm +/- 20μm, blasted sharp edges (blasting material G). Recommended surface preparation grade Sa 2,5.
The processing time (potting time) of the material begins as soon as the two components A and B have been completely mixed with each other by means of a mixing coil. Potting time and curing time depend on the amount of material (volume) and temperature. With larger containers, the potting time may be reduced due to a higher reaction heat. The material hardening can be accelerated by heating. The maximum permissible temperature for accelerated curing is 50°C. The required curing temperature is 5°C . At low temperatures it is recommended to preheat the components.
RepaCoat CP-V is sprayed with the RepaCoat Venturi system. The system works with compressed air and 8bar pressure [RepaCoat Venturi spray gun (prod no.:8154), Venturi mixing coil (prod no.:8155) ].
No manual mixing is required when using the RepaCoat Venturi system.
Our payment and shipping partners
Do you have any questions? We will be happy to help you.
Would you like expert advice on which of our products is best suited for you? Then simply contact one of our service technicians! We will be happy to help you, whether you contact us by phone, fax or mail.