FL/P

Storage / Shelf life Store in the original, unopened container in a dry, cool and frost-free place (+5°C to +20°C). Shelf life 18 months. Protect from direct sunlight. Higher temperatures reduce the shelf life. Processing the adhesion surface The guide surface to be coated is roughened to improve adhesion. The roughening depth should be 0.5 mm (Rt-500 µm). The roughening can be produced using a cutter head with a high feed rate on a milling machine. Surfaces must be clean, dry and free of grease and oil. For cleaning dirty surfaces, we recommend DIAMANT Cleaner #1417 or DIAMANT Cleaning Spray #1534. Surfaces to which DWH should not adhere should be coated with Release Agent #1354 or Release Spray #1355. Mixing procedure To mix moglice FL/P, pour component B completely into the container of component A. Mix intensively using a drill and the DIAMANT mixing propeller (Prod. No. #0789) (max. 250 rpm for approx. 2 minutes). Remove any material adhering to the walls of the container with a spatula and add to the mixture. Mix thoroughly again. Deaerate moglice FL/P should be poured into a clean container in a long, thin, uninterrupted stream. Application description Transfer moglice FL/P into a 1K empty cartridge and inject it through an inlet channel into the prepared, sealed cavity. To avoid the influence of air, fill the cavity from the deepest point. Alternatively, the moglice FL/P can be poured onto a chamfered surface. Use a spatula to support the even flow. After curing, finish the surface. Qualification and service To ensure the best possible quality and error-free application, we offer the following services: Advice by telephone and/or on site at your construction site Site supervision and monitoring of the work on site Complete execution of the work by our experienced application technicians Further information can be found in the service data sheet.